In this post, we begin with a 1963 Corvette interior installation process. We assembled multiple components for the interior and installed various weather stripping. Restoration and installation of the front parking lights and the hood release cable were also conducted. Here is the rear section of carpet that covers part of the wheel wells. According […]
In this post, multiple 1963 Corvette electronic components are refurbished and installed. We installed the gauge cluster and all of its components in the 1963 corvette. We blasted and painted the jack and handle. After the jack and Handle were refurbished, the team installed the radio, defroster duct, radio speaker, speaker grill, and voltage regulator […]
In this post, the team restored and install 1963 Corvette cover assemblies. We fixed and painted the air cleaner assembly for the 1963 Chevrolet Corvette, installed the dash board, and carpeted and labeled the storage compartment cover. This is the heater blower motor. In 1963 Corvette, only the blower motor was coated with an undercoating […]
In this post, we demenstrate the process taken to redo and reconstruct 1963 Corvette Brakes, Seats, and Assembly Marks. Here we assembled the front brakes, rebuilt the hubs, installed the hubs and brake drums, marked the steering arms and spindles with assembly paint, and upholstered the seat bottoms. Here is the seat bottom with the […]
In this post, we’ll show and demenstrate the process taken to install and repair our 1963 Corvette Front Suspension and Seats. We have put the assembly marks on the front springs, installed the springs, spindles, brake backing plates, steering arms, and sway bar linkage. We also have rebuilt the ball joint on the steering relay […]
In this post, we will show and demenstrate the process taken to install and dissasemble our 1963 Corvette Control Arms and Seats. We have finished assembling and painting the control arms, installed the upper control arms, and disassembled the seats. We noticed that the two lower control arms had different styles of cross shaft installed. […]
In this post, we will show and demonstrate the process taken to complete the 1963 Corvette Split Window Coupe Body Removal Part II. Today we removed the body from the Chassis. We had to make some modifications to the lifting frame to provide more support to the body. We added an additional lift point in the […]
In this post, we will demonstrate and show the process taken to complete the 1963 Corvette Body Removal Prep project. We are ready to remove the body off the chassis and have fabricated brackets and a lifting frame to remove the body. We fabricated a set of lifting brackets that bolt tot the door jamb were the striker […]
In this post, we will demonstrate the process taken to complete the 1963 Corvette Bodywork and Repair on the Split Window Coupe. We have finished stripping all the paint off the Corvette and have started the body work on it. We have also receive a few more of the original parts for the Corvette. The next […]
In this post, we ill show and demonstrate the process taken to complete the 1963 Corvette Paint Removal and Prep. As you have seen we have pretty much finished disassembling the car and have started stripping paint. We also have some neat photos for you of how the factory painted these cars. This is a photo of the […]