Archive | Fuel and Ignition Systems

RSS
P9100050

1968 Ford Mustang Comes Out of Storage

0

Classic cars just sit…..and sit…….and sit, until finally someone gets tired of paying storage or gets the motivation to see the old car ride again.  This was just the case for our 1968 Ford Mustang.  The car’s California registration ran out in 1991 and since we are in Washington I think it is safe to […]

P9200066

1979 F350 Ford 7.3L Powerstroke Engine Swap

0

In this post, we will show and demonstrate the process taken to complete the 1979 F350 Ford 7.3L Powerstroke Engine Swap. Welcome to another  project at the Auto Club.  We are  taking a 1979 Ford F350 single rear wheel four wheel drive truck and installing a 7.3L Powerstroke diesel that we removed from a 2000 Excursion.  This project […]

1963 Corvette Performance Verification

0

Here’s an update on a 1963 Corvette performance verification. Multiple systems are inspected and judged. This little bar is what controls the air flow for the heater box.  The linkage was pulled from the console and inspected for any major damage, which was then reinstalled.  Adjustments were made to the cables to allow the heater controls […]

In this thread, we

1963 Corvette Transmission Heat Shield, Ignition Shielding, and Valve Cover Decals

0

In this thread, we’ll show you step-by-step on how to bring your 1963 Corvette Transmission Heat Shield, Ignition Shielding, and Valve Cover Decals back to life. Here we installed the tunnel heat shield, removed improper markings off some of the shielding mounts, installed the lower choke tube, and installed the decals on the valve covers. For […]

1963 Corvette Differential Install and Fuel Tank Stencil

1963 Corvette Differential Install and Fuel Tank Stencil

0

In this post, we demenstrate the process taken for a 1963 Corvette Differential Install and Fuel Tank Stencil. Here we stenciled the 1963 Corvette fuel tank, assembled and marked the differential, installed the differential, assembly marked the transmission shifter cover, and assembled the rear spring pack. With the use of cardboard, we masked and painted the […]

1963 Corvette Engine, Transmission, and Differential

1963 Corvette Engine, Transmission, and Differential

0

In this post, we demenstrate and show the process taken to rebuid and assemble the 1963 Corvette Engine, Transmission, and Differential. Here we assembled parts and pieces on the engine, rebuilt the differential, and started on rebuilding the transmission. Here is the intake and valve covers installed. Here is the heat shielding and radio shielding installed. Next we […]